Earthquake Swarms

Earthquake swarm of December 2004 across Eastern Trinidad

Earthquake swarm of December 2004 across Eastern Trinidad

Earthquake swarms are a series of earthquakes within a local area, occurring within a relatively short period of time. These swarms can occur over the length of hours, days, weeks and even months. They are different from earthquakes that result in aftershocks as no single earthquake can be identified to be a clear main shock in the sequence.

Generally, in a typical earthquake sequence, there are sometimes foreshocks, then the mainshock (the largest magnitude seismic event) and then an aftershock sequence (all seismic events proceeding the largest registered magnitude earthquake).

These are rolling definitions, meaning that during the “aftershock sequence,” if a larger magnitude quake occurs in the same area at a similar depth, that would be considered the new mainshock, all prior quakes are now foreshocks and subsequent smaller magnitude quakes are aftershocks.

In addition, there are no set definitions or time periods of what constitutes as a mainshock or foreshock. In fact, based on present definitions, we can state that some of our current large magnitude events (which occur in the same location and depth) of historical large magnitude seismic events can be considered part of that aftershock sequence.

Graphical representation of an earthquake swarm and a typical earthquake sequence. It should be noted that, in a typical sequence, foreshocks do not occur in every case. Credit: ETH Zurich

Across the world, earthquake swarms occur, with hundreds to thousands of earthquakes occurring across several months to years that could be directly attributed to a swarm. Generally, swarms are thought to result from ‘fault creep,’ when faults become unstuck and slide rapidly for some period, perhaps lubricated by the release of fluids. Seismic swarms often precede eruptions, but only rarely precede large earthquakes.

The two most dominant hypotheses, explaining the occurrence of earthquake swarms, are the influence of magma and groundwater injection.

Magma (Volcanic) Earthquake Swarms

In the Eastern Caribbean, where volcanic islands exist, most of the earthquake swarms that do occur are typically volcano-tectonic in nature. Volcano-tectonic earthquakes are earthquakes induced by the movement of magma or fluid underground. This movement can cause pressure changes, causing the surrounding rock to break or move and trigger minor earthquakes.

The most recent case of this type of swarm is on the island of Guadeloupe, in the area of La Soufrière. Over the course of 12:19 AM January 19th 2019 through 6:51 AM January 23rd, 2019, the Volcanological and Seismological Observatory of Guadeloupe recorded 501 seismic events, all at a depth less than 2.5 kilometers and less than magnitude 1.0.

Fracking & Waste Water Injection Earthquake Swarms

In cases where hydraulic fracturing, also called fracking, or wastewater disposal occurs underground, induced earthquakes can occur. In places like the United Kingdom and Oklahoma in the United States, wastewater disposal and (sometimes) fracking have induced earthquake swarms. The cause of these earthquakes, according to the United States Geological Survey are as follows:

“Earth’s crust is pervasively fractured at depth by faults. These faults can sustain high stresses without slipping because natural “tectonic” stress and the weight of the overlying rock pushes the opposing fault blocks together, increasing the frictional resistance to fault slip. The injected wastewater counteracts the frictional forces on faults and, in effect, “pries them apart”, thereby facilitating earthquake slip.”

Earthquake Swarms In T&T

In the Trinidad and Tobago region, neither of the above causes of swarms occur. Within the seismic zones, there is little to no subsurface wastewater disposal, nor are there magmatic volcanoes triggering earthquake swarms. The prevailing theory for regions such as ours is that these quakes are related to stress release on smaller faults, within a fault system.

Over time, as the South American Plate and the Caribbean Plate moves past one another, stress builds up across these major fault systems, which include smaller perpendicular faults. When stress reaches a critical point, these small earthquakes begin to occur. Since these faults are fairly small compared to the larger regional faults, such as the El Pilar fault and the Central Range fault, these earthquakes tend to be minor to micro-sized (<M3.0). However, these quakes can occasionally occur at magnitudes greater than M4.0 and even M5.0.

These seismic swarms are regularly detected by seismic monitoring agencies such as the U.W.I. Seismic Research Centre for Trinidad and Tobago, as well as the remainder of the Eastern Caribbean and the Venezuelan Foundation for Seismological Research for Venezuela.

Most swarms can only be detected by seismographs, as the magnitudes are generally too small to be felt. At times, there may be a larger quake within this swarm that can cause some alarm, but usually, no damage or injury occurs.

Notable swarms include the East Trinidad swarm of 2004, the Southwest Tobago swarm of 1997 and the other Southwest Tobago swarm of 2016-2017.

Does a swarm mean the ‘big one’ is coming?

No. Although large earthquakes are sometimes preceded by smaller associated earthquake swarms (called foreshocks), swarms of seismic activity do not necessarily indicate that a large earthquake is to follow. It is important to reiterate that earthquakes cannot be predicted.

However, tiny earthquakes increase earthquake risk because they increase the overall earthquake frequency on a given fault. If these swarms of quakes are occurring on smaller faults, that run perpendicular to the main fault (i.e. the El Pilar Fault, Central Range Fault, etc.), these smaller earthquakes increase the likelihood (probability) of a larger earthquake occurring on the main fault. It is impossible to predict whether this larger quake will occur.

Would an increased number of small earthquakes reduce the chance of a larger earthquake occurring?

Seismologists have observed that for every magnitude 6 earthquake there are about 10 of magnitude 5, 100 of magnitude 4, 1,000 of magnitude 3, and so forth as the events get smaller and smaller. This sounds like a lot of small earthquakes, but there are never enough small ones to eliminate the occasional large event.

It would take 32 magnitudes 5’s, 1000 magnitude 4’s, OR 32,000 magnitude 3’s to equal the energy of one magnitude 6 events. So, even though we always record many more small events than large ones, there are far too few to eliminate the need for the occasional large earthquake. (Source: USGS)

Facebook Comments